2 Connector Speaker Wall Plate
Put the finishing touches on your installation with speaker wall plates. You can use multiple plates in an array for a complete connection solution for your wall and ceiling speaker termination. Use decora light switch cover plates over the top of multiple speaker wall plates.
Usage: These will accommodate 1 Speaker
(Speaker A: Left + - Total 2 Connectors)
| You will receive: |
|---|
| 1 Brass Binding Post, gold plated - Red | | 1 Brass Binding Post, gold plated - Black | | 1 2-Hole Insert | | 1 Single Gang Decora Wall Plate | |
Transcript of the Video above:
"This is a video review of our wall plates called "WP8", "WP4", and "WP2. And "8" is an 8-connector. One each for positive/negative for one speaker, two speakers, three and four speakers. You have one pair of speakers and two pair of speakers, so one of these holds two pairs of speakers. And this one will be for one pair of speakers. The left and then the right. You can thing of those as rows if you like. That's a little easier to operate on. And this is the single, "WP2". Some of these will come packaged like this, some of these will be packaged in zip-locks. Just depends on what manufacturer we happened to get them from. They are pretty generic. So we are trying to get them from the least expensive source.
So let me show you how these things work. They are a pretty simple device. There is not much to them. On the front and back there are the same connectors. These things screw out with your thumb screw. As these come out, they expose underneath the hole where the wire goes in. This will be the back side of your wall. You cramp that down. On the front side you can use either bare wire put in the same way, which is what we recommend unless you are going to move around or you can use a banana jack. And those will go right in there, into that little hole right there. So this is for one pair of speakers, a left and a right. And if you need to do more of them in a row, you can also use a multiple decora installation and a larger J-box. You can do up to four and each one of these will fit in each one of these slots. You put four across here. And then you just put a cover plate over the top. This is a dual cover plate. It fits nicely in there. You can also label these yourself and save yourself a little bit of money over pre-labeled ones. You can make them in any configuration you want, a couple four's a couple two's, however you want to go."
HOME
